Drain Plug Kit fits MerCruiser sterndrives and outboard applications.

Gear Lube Drain screw with gasket for most Mercury lower units.  (Also used as vent screw in 1963 and newer 35HP and larger non-racing gear cases.)

Was 10-79953T2

This is used as both drain & vent on 1974 & prior models.  1975-76 use this for vent screw and 22-67892A06 magnetic drain screw.

Mercury Premium Gear Lube for use in gear housings of all Mercury, Mariner, and Force outboards. 8 oz.

1/4" braided nylon starter rope with wood handle, suitable for any Merc without a recoil starter

Prop Nut & Tab Washer Kit includes a special locking nut and two tab washers.  Fits 4 and 6 cylinder models 65HP & larger 1969 to present.

Water pump base oil seal for Merc 650 (4 cyl), 800 (4 cyl), 850 (4 cyl)

Merc 650, 700, 850, 900, 950, 1000, 1100, 1150, 1350, 1400, 1500

Merc 650, 700, 850, 900, 950, 1000, 1100, 1150, 1250,1350, 1400, 1500, 1750

Starter Solenoid used on many starter and power trim applications 1972 to present.

(Replaces 47-30221 & 47-65960 & 47-89984)

Fits all 4 cyl. 65, 80, & 85 HP models all 6 cyl. engines with gearshift thru 1993 also fits Merc 800 direct reversing.

Aftermarket Water Pump Impeller Kit (includes impeller, gaskets, wear plate, etc.) fits all Mercury 4 cyl. 65, 80, & 85 HP models, all 6 cyl. engines 1963 thru 1993, and fits MerCruiser I/R/MR/Alpha drives (s/n 2495186-0D469858).

Water pump kit

OEM Mercury Water Pump Kit includes plastic pump housing assembly, impeller, face plate, gaskets, drive key or pin, water tube guide sleeve, orings and gear lube fill & vent screw seals. (Pump base not included) Fits all Mercury/Mariner  4 cyl. 65, 80, & 85 HP models, all 6 cyl. engines 1963 thru 1993 and fits MerCruiser I/R/MR/Alpha drives (s/n 2495186-0D469858).

5 Post ignition switch with 2 keys.  Fits controls and dash panels for 2 cylinder models 1970-79, 4 cyl. models 1960 thru 1979, and 6 cyl. models 1966 thru 1979.  Also fits 4 cyl. controls 1954 thru 56 with metal motor connector.   Replacement keys also sold individually below.

Lower Unit Resealing Kit includes all seals, gaskets & o-rings. (Does not include gasket & seal for cooling system flush plug) Fits 4 & 6 cyl 65 to 150 HP inline models from 1963-1986

Internal Wiring Harness fits 1976 and 1977  Merc 850

Mercury starter motor for many 3 & 4 cylinder models 1976 thru 1996

Replaces Mercury Part #50-66015T1