Gear Lube Drain screw with gasket for most Mercury lower units.  (Also used as vent screw in 1963 and newer 35HP and larger non-racing gear cases.)

Was 10-79953T2

This is used as both drain & vent on 1974 & prior models.  1975-76 use this for vent screw and 22-67892A06 magnetic drain screw.

Gear Case Vent screw with gasket for gear cases of many smaller Mercury Outboards.

Gear Grease- 105 Lubriplate replaces original gear grease in all 1, 2, & 4 cyl. Mercurys through 1961. This heavier lube should also be used in non-shift motors of other brands. 10 oz.

Note: Modern 90 weight gear lube is generally unacceptable in these engines.

This is the top crankshaft seal for models K, KB & KD models, KE3, KE4, KE4A, KF3, Mark 7

This is the bottom crankshaft seal on the KF-3 for serial # 358552 thru 358612 and 358616 & up.

This is the drive shaft seal for Mark 10, 10A, 15A, 28, 28A, 40H, 55H, Merc 100, 150, 200, 350, 500, 650

This is the prop shaft seal for Mark 75H

Mark 10, 10A, 15A, 28, 28A, Merc 100, 150, 200

Fits KE7, Mark 10, 10A, 15A, 28, 28A, 28AD, 15, 20, 30, 30E
Merc 100, 150, 200, 250, 20, 60

Mark 10, 10A, 15A, 28, 28A, Merc 100, 150, 200

Aftermarket water pump impeller
Fits all Mark 10, 10A, 15A, 28, 28A, Merc 100, 150, 250 & Merc 200 thru 1965.
May need to be modified by filing the keyway to make it square.

Lower Unit Seal kit contains all lower unit seals and gaskets for automatic transmission models Mark 10,10A,15A, Mark 28, 28A, Merc 100, 150, 200 (with auto trans.) and Merc 250. Does not include the seal & oring above the impeller on models with open bottom pump housing.  Unnecessary removal of this housing is not recommended.